60" L X 36" W X 8" H; supports up to 150 lbs.
Weight: 6.16 lbs.
Thickness of PVC: 18 gauge.

1. Inspect your AeroBed for Kids prior to each use.
2. Keep your bed away from any sharp objects. Large cuts or snags may not be repairable and will not be covered by your Aero Sport WeekenderBed Raised warranty.
3. When not in use, store your bed in a clean, dry place out of extreme temperatures. Do not allow pump or charger to get wet at any time.
4. In case of incidental damage to your bed, a repair kit with instructions is included with each bed. Please follow repair kit instructions carefully. Additional vinyl repair kits can be purchased through Customer Service.
5. Do not allow water to enter your Aero Sport WeekenderBed Raised through the Air Release Valve. If water does enter the bed, make sure to empty it and completely dry the bed before storing.

1. WARNING: Adult supervision required. Follow all safety instructions to avoid serious injury.
2. WARNING: This product has an electrical component that is not a toy. To avoid risk of fire, burns, injury and shock, it should be not played with or placed where small children can reach it.
3. Remove all sharp objects from area where bed will be set up and used.
4. Do not use this product on abrasive surfaces or near pointed/sharp items or surfaces. Protruding objects may puncture mattress.
5. The mattress is made of PVC and therefore may melt or burn if it comes in contact with any flame or heat source. Do not place it near or against heaters, open flame or other hot objects.

Problem: Bed has a broken part

Your AeroBed for Kids and pump are guaranteed to be in perfect condition when you receive it. The bed and pump are also guaranteed to perform under normal usage conditions for one year from the date of purchase. If, upon purchase, you discover your bed or pump is in some way defective, or if a part breaks within the warranty period, contact Consumer Services, or return it to the place of purchase for a refund. All parts are replaceable.

Problem: Air Release Valve is broken

If your valve is damaged (e.g., the tab has broken off), you can request a new valve, contact Consumer Services.

Problem: Product is leaking air.

1. Air is leaking from the Air Release Valve.
   
   If air is leaking from Air Release Valve, carefully remove the round black plastic gasket (or white silicone gasket, depending on model) inside the Air Release Valve cover.
   
   Rinse this gasket in warm water for 10 minutes, then cool and towel dry.
   
   Re-insert gasket in the valve cover, making certain that the side of the gasket with the U-shaped groove faces into the cover. Leave valve in open position for approximately 30 minutes. Then close and proceed with inflation instructions.
   
2. Air is leaking from a puncture or tear in the product.
   If you have a puncture or tear in your product, it may be possible to repair the damage by using the Vinyl Repair Kit included with your product. Follow all instructions and heed all warnings included in the repair kit.

Problem: Bed won't inflate.

1. The Air Release Valve is open. If the valve is open, close it by using two thumbs to push cover and snap it into valve.
2. The pump is not charged. Charge pump according to directions in instruction manual included with your Aero product, or see instructions on this website.
3. The pump is not plugged in (if your AeroBed for Kids included the Instant On AC Pump). Plug pump into any 110 Volt AC electrical outlet (220V product sold outside North America).

Problem: My rechargeable pump got wet. What do I do?

Once water gets inside the rechargeable pump, it may no longer work. Replacement pumps can be purchased by visiting our Accessories page.